https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEhA4U1QVCqA1D89hTfnLg8G7GHNjfJnIg9zmCBKseJagLQRSaO0De_g36dMDbf928Gf5yCkc5icFjUEN4TDNJ0Kws05Sw2JpsIH6QxI6FaYRI6EuiVZ3N89dTJvp6otMAajpjr94f0LQH4/s400/cewek_cantik_8.jpg
Read More >>
Customer Reviews
Most helpful customer reviews
6 of 6 people found the following review helpful.
Perfact match but a minor problem
By ceconomon
This air intake hose was a perfect fit for my Mazda. It looks exactly like the original. The original intake tube was torn in the accordion folds. This caused a CEL P0174 (lean on bank 2).
I did have one problem with the product. After the install, my car started making a strange squealing noise about 30 seconds after the car was started. I removed the intake hose and inspected it carefully. I discovered the vacuum line on the hose was sealed. The hose came with the new vacuum elbow fitting already installed so who would think to verify vacuum line was opened all the way to the hose. There were no instructions included with this part to clue you in to this. I guess if you work on cars all the time this is common knowledge. I drilled the hole out and the noise is gone.
2 of 2 people found the following review helpful.
Almost perfect
By Casey E. Byron
Part is exactly as ordered and was nearly a perfect fit for my '05 Mazda 6 V6 MT. Had to slice off a small section near the intake valve for the O2 sensor connector in order to make it fit properly, and the stock connection was a really tight fit in the replacement hose. A little bit of oil and some elbow grease and it's done. Over all, with any mechanical skill at all, this can be a quick install for the every day driver.
Part appears to work just fine. Very slight alteration in sound of the intake, but I also installed a K&N filter, so it may be due to the filter itself.
Very satisfied with the product.
2 of 2 people found the following review helpful.
For less than a half that Dealer asked me
By D. Kolar
WOW, when I called the local dealer, they have asked me $135 for the same part. I have installed this 3 days ago, and the installation went well. The part is exact fit for my 2003 Mazda6 S, and it does NOT look like it is made from cheap rubber. It took me about 10 minutes to take the old one off (it ripped between the ridges) and install the new one. I hope that I will not need the new one, but if I do, I will definitely buy again.
0Awesome Comments!